Advanced Keys AK-PSB05 Guía de instalación

ADVANCED KEYSSmart Keyless Entry SystemINSTALLATION GUIDEAK-104REV: A05-11-1118www.advancedkeys.com [email protected]© Copyright Advanced Keys

10© Copyright Advanced Keys Inc. 2011. All Rights Reserved. If required, use the following procedures to program a new set of Smart Key and/or Bypas

11© Copyright Advanced Keys Inc. 2011. All Rights Reserved. Controller operating voltage range: ...

2© Copyright Advanced Keys Inc. 2011. All Rights Reserved. Table Of Contents ...

3© Copyright Advanced Keys Inc. 2011. All Rights Reserved. • This product shall be installed by a certified technician therefore a certain level of

GreyGreyRedGreenBlueBlackPurple7.5A7.5A15A15A15AMain Harness8-Pin 18 AWGParking LightParking LightBattery +12VLockUnlockGroundHorn Control+-++---JP

WhiteOUTPUT 500mAStarter Kill Relay Control(Starter Kill Relay is not required if installed with AK-PSB05)Depending on jumper (JP2) selection this ou

WARNING: M anuf acturer/Distributors of this product w ill not be responsible for an y electric al d amage resultin g fromimproper installation of th

Review product manual manual. Prepare vehicle for installation.Review and set controller jumper settings according to requirements.Connect Main and Ac

ANTENNAS INSTALLATIONAntennas should be mounted on a Non-Enclosed and Non-Metallic material such as clear glass or plastic trim panels. Recommended p

FAQWhy is key detection not working or the range is very sort?Verify antenna position: Antenna may be on or close to metallic material, change positio